Thumbnail

Wowwee MIP Movement Panel

+ How To Add This Control To Your Project (Click to Expand)
  1. Load the most recent release of ARC.
  2. Press the Project tab from the top menu bar in ARC.
  3. Press Add Control from the button ribbon bar in ARC.
  4. Choose the Movement Panels category tab.
  5. Press the Wowwee MIP Movement Panel icon to add the control to your project.
The WowWee MIP robot is hackable with a UART port on the main board. Connect the GND, TX and RX to the EZ-B's UART Port 0 TX and RX to control it from the EZ-B v4.

We found that the batteries in the WoWwee were not strong enough to power the EZ-B v4 & camera at the same time, so we connected an additional 9volt battery to power the EZ-B v4.

*Note: Remember that if you are powering the EZ-B v4 off a seperate power source, you will need to connect the GND together. It doesn't matter where the GND's come from, long as they are shared between the MIP and EZ-B v4.
Note: Synthiam is not a manufacturer of this third party hardware device. . Nor is ezrobot responsible for the operation of this third party device. For operational questions, it's best to consult the instruction manual for operational instructions.