Behavior Control
Help Index

BV4113

How To Add This Control To Your Project

  1. Load the most recent release of EZ-Builder
  2. Press the Project tab from the top menu bar of EZ-Builder
  3. Press Add Control from the button ribbon bar of EZ-Builder
  4. Choose the HBridge category tab
  5. Press the BV4113 icon to add the control to your project
EZ-Robot Certified HBridge Movement Panel. Always connects to Pin D0.



This is an EZ-Robot Certified Economy Motor Controller. It is capable of 1.5 Amps (5 Watts) between 5 and 12 volts DC. This convenient motor controller connects to the EZ-B by a single cable.



The cable to the EZ-B provides +5, GND and Signal for the Motor Controller Communication



The other connections are for your motors and motor power.



*Note: The IC on the board will get very hot if your motors draw too much current. Consider adding a heat sink to the chip: DigiKey Heat Sink