Arduino Leonardo

Arduino Leonardo

Connection Type
USB
Number of servos
12
Audio Support
No
Camera Support
No

The Arduino Leonardo can be programmed with the EZ-B firmware for a variety of capabilities when connected to EZ-Builder. Find the firmware below. The tutorial to program the EZ-B firmware can be found HERE. This firmware works with EZ-Builder versions greater or equal to 2019.06.25.00.

* Connection Notes *

Due to an undocumented bug feature (?), the Arduino Leonardo's USB serial driver requires DTR Enabled to trigger received data events. This can be done by viewing the Connection Config screen (same place you set the baudrate) and checking DTR Enabled checkbox.

Arduino Firmware

In the meantime, download the Ardiuno firmware below. You can program on the Arduino Leonardo. By adding this firmware, you can connect EZ-Builder to the Arduino via USB and control the GPIO directly.

Download Arduino Leonardo Firmware: EZ-Genuino_Leonardo.zip

Pinouts

The Digital pins from 0-14 can be used for PWM, servos and digital on/off. The ADC ports are 0-5 for analog input. Digital pin 0 is Uart #0 RX, and digital pin 1 is Uart #0 TX.