Here is the current look of this project, Super cool update, magpi magazine wants to feature this build with steps how it was done , !
More robots by jstarne1
Other projects from the same builder.
Jstarne1's Sky Anchor ,Gig Wifi Drone
Hex coaxial drone with 12 props and 15 lb thrust, 3D-printed frame to lift a WiFi antenna and camera for extended robot...
Jstarne1's Air Tunnel Plus Bot The Smartest Way To Kills...
UV air sterilizer and mobile disinfecting robot with RGB, pest trap, scent control, timed ozone/ionize, motorized UVC...
Discover more robots
Robots the community built with Synthiam ARC. Get ideas for your next build.
Wiinteru's EZ-Boxbot With Iotiny
EZ-BoxBot remake replacing EZ-B V3 with EZ-B IO Tiny; V2 adds rotation servos, new camera, RGB eyes, painted chassis and...
Billderwent's Boris V2
Boris V2 Dagu Rover 5 upgraded from EzB/Mecanno with 4 motors and encoders, separated channels and secured encoder...
Cirkeith's Upgraded Wall-E
WALL-E inspired mobile robot controlled by a wireless Xbox 360 controller, upgradeable with EZ-B kit and embedded...


I have picked up a few Jazzy power chairs and pulled the seats off of them. I will further remove stuff that I don't need. I have seen people hack the original motor controllers but I feel like I am better just selling the original on Ebay and buying one made for DIY building instead. My first power chair base project I used a Sabertooth 2x12 ,but I do have a couple other generic controllers I picked up that may work just fine. I will post some pictures, thoughts, goals and parts I have to work with so far. Any input is cool.
You have two threads with a similar subject (wheel chairs). Which one you will keep updating ?
I dont see the second one , Are you talking about the power chair thread? Because thats not for specifically my projects but general ideas for power chair robots. Thats a free for all discussion.
This is a Project showcase for the Outdoor Security robot build.
I missed the "Project showcase" tag.
General Goals
a mobile platform that can patrol a set routine
Motion tracking , robot turns towards movement and tracks that object/ person
3-4 cameras recording 24 / 7
run without outside power for at least 12 hours, but the goal is excess of 24 hours.
-Even in the even the robotic size of the electronics fails or the battery runs dead, there is a backup that keeps the cameras on and recording.
-Recording both locally on the robot itself and also wireless video sent to a recorder that I will probably setup with another raspberry pi.
Live access to the cameras over the internet
1 tb hard drive dedicated to every camera, covers recording in HD for at least a rolling month. Recordings in 10 min intervals.
-Dual battery setup, one battery for the drive wheels , motor controller and ezb Lithium battery 10,000 mah packs for each camera
-Safety Stop switch that cuts power to motor controller in the event of an emergency, but everything else still records.
-Create a water resistant area protected from spashing and weather for the electronics
-make some kind of seal where the panels come together
-GPS geofence alarm and active tracker
GPS tracking unit, with built in battery so it tracks even if the main battery is removed.
https://www.ebay.com/itm/232479396529
No IR Raspberry Pi 5mp camera with 130 degree lense