Asked
— Edited
Resolved by Jeremie!
3D Print Jd Head
hi
has anyone printed a jd head?my question is ,how do you print the head on the printbed?
thank you
Related Hardware (view all EZB hardware)
JD Humanoid
by EZ-Robot
JD humanoid robot kit - WiFi-enabled, 16 DOF with metal-gear servos; easy, fun, educational, available from the EZ-Robot online store.
Wi-Fi / USB
Servos
24
Camera
Audio
UART
3
I2C
ADC
8
Digital
24
Related Robot Skill (view all robot skills)
File Manager
by Synthiam
Displays files currently open for reading by scripts, shows only read-opened files, helps diagnose read/write locks and file access errors.
hi nallycat
you are spot on.thank you for saving my printer.it was a new complete heatblock with a faulty throat.
i could nof figur out why the filament did go smooth in the block, and when its in , i couldn get it out to swap filament. much learned.@Normad6R you are welcome if the stepper keeps clicking after you fix the blockage then it is damaged. you will have to replace it, I hope not, but it has happened to me, we learn by our mistakes.
Lucky.it works,doesn click,xD back to printing.
the real problem that started the tok tok sound is this. i negleted to check the new nozzle.i was assuming it was good. it was loose and cause a cloth in the nozzle.
does this picture look normal?
@Normad6R No it does not look normal. You need to check your extruder it is not putting out enough filament. print a test cube and check your settings. did you tighten the grub nut on the feed gear. and it is tight. and check the filament leaving the hot end if you extrude 20 mm is 20 mm coming out.
hi nallycat
lot of filament is comming out,but not line next to line .more like a V chape. also the lines off the raft do not stick together.i use 220 heat.no heat on the bed. i just checked the grub nut is ok. it feels like the sync off the bed and nozzel is off.
@Normad6R download and print a test cube no raft. reset the bed level to make sure you are the correct distance to the glass. and see how it prints.