All Community Content

STL Doesn't Match Print

i printed the backpart of a lever servo,and i notest the file is not correct with the print? i notest some other parts doesn match.

Google Home And EZ-B

Hi guys, Is there a way to use/integrate google home with EZ-B/Synthiam? I have been locking for a tutorial but didnt find one. Regards.

I2c Help

This document is outdated because ARC now converts the address for you. This document may be referenced for educational purposes. Binary i2c is not entirely about binary. But the address sure is! That is because most addresses are defined as 7 bit values. And if you keep reading, you'll see that changes need to be done to use that value in a byte;...

Playing A Sound

Hi, I'm trying to make a plugin that could play some specific sound on my Ez-Robot. I used the following tutorial : https://synthiam.com/Tutorial/How-To-Make-An-EZ-Builder-Plugin-16328/25 I'm stuck at the point where I compress the PCM Data with GZip :                 using...

JD Camera Recording

Hello,  I'm trying to record a video from JD's camera - I have tried to use :   "_camera.StartCamera" and then "_camera.AVIStartRecording" but it doesn't seem to work.. I'm not sure if it is the right way and what videoCaptureDevice argument should be?  Maybe someone have an example for recording a video?  Thank you, Orit

Ez-Arduino With L293

I used the L293 module connected to arduino, the ultrasonicsensor to make the rotbot automatically avoid obstructions, so when I turned the arduino into ez-b, I could connect it to L293, the ultrasonic sensor and do that project withez-cript similar to the code C++ II wrote and it doesn't seem to work?

Speech Delay BT Speaker

Sorry for all the questions. I try to test and research before asking. I have a issue that's bothering me and can't seem to figure it out. I'm using a Alfawise X5 from gearbest and a BT speaker. Whenever I use any kinda speech trough the BT speaker. There is a slight delay and the 1st word is not spoken. Iv'e tried setting the speaker as the...