Robot Building Community

Assigning Joystick Button Script To Control Ports On Different Ez Boards

Can you assign joystick button script to ports on different EZ Bs? There seems to be no place to specify which board the script is meant for. Is there script syntax to address this? Thanks

Help Needed Converting This Script From Python To Ez-Script

I have switched my robot over to Ez-Robot and I need some help converting the following Python script over the EZ-Robot language. if (data == "lets do some math"): math() if (data == "one"): one() global first first += 1 print(first) if (data == "two"): two() global first first += 2 print(first) if (data ==...

Dinsmore 1525Nd Hall Efect Compass Sensor

I wanted to share my new find with others. at a local hamfest I purchased two Dinsmore 1525ND nd for no damping on outputs electronic hall effect sensors for $5. these sensors have both sine and cosine outputs. I have attached a data sheet for reference. So far the results are pretty good, now to interface it to EZ v4 instead of my development...

Help With Array

Good Afternoon. I want to create an array where I store two string values. For this example I will call it $x and $y. I want to store the variables in the array. I want to store as many as I need. I understand the definearray command. What I do not understand is how to input in the array and keep adding the string variables. Let me post my example....

Ez-Robot Rebooting Every Time I Use A Servo

Hello Everyone, I require assistance once again and I apologize for bothering you, but I have yet another problem. I go to keyboard control and set the w key to Servo(D13,25). I press w and the servo moves but then my EZ-Bv4 restarts and reconnects every time I do this. Thanks in advance, Crazy