Robot Building Questions

Connection Chime

Heya guys. Anyone know if its possible to disable, remove, or replace the "i have successfully connected to your network" chime from the connection startup?

Can't Configure Rovi As A Wifi Ap

We are trying to reconfigure the Rovi to be a Wifi AP. We can connect to the Rovi via my router, we can access the Rovi's configure pages, both from my PC and my tablette, we can apparently save the "EZ-B Wi-Fi Access Point Mode Configuration", we then reboot the Rovi, either using its power switch or the reboot option from its Diagnostic...

2S Lipo Vs Servo

First I like to say that i'm very happy with your products But here we go A fully charged lipo puts out 8.2 volts and the servo's that are in the kits can have max 7.4 volts. I used in my projects cheap towerpro 995 servo's and a stepdown regulator to put out max 6 volts because if i put the full lipo voltage on them they begin to smell funny and...

Camera Grid Lines

I find when using the Camera, the grid lines change or fail to stay as set. I try to save the set locations of the lines, but when I reload the project I have to reset the grids again. Thanks, Ron

Script Question

Please have a look at this script. Will it run all the way through or will the Halt() command in the first "if" statement cause it to stop before it gets to the "Elseif" section? Thanks for looking. if ($ADC_Lft_Elbow => 160 )#160-350 is in Centered position $Lft_Arm_Centered = 0 #Reset varable 1=not cnetered, 0=centered...

Looking For Stl Files To Print

Hi, I am trying to find a download point for the STL files to make the servo mounts for a JD arm servo? Anyone point me in the right direction? Thanks Paul

Product Questions

Hi I'm interested in your platform, and I have a few questions: 1. Is communication established by direct WIFI connection or is a router or internet connection required? 2. Can the robot be programmed with Arduino? Are there libraries to allow programming with Arduino? Thanks.