Robot Building Questions

Servo Control Voltage

I don't have a scope to verify this but would I be correct in assuming that the servo control voltage going to the servo is 3.3 volts on any particular digital port that a servo is connected to on an EZ Controller? The power to the servo would be the battery voltage that the EZ Controller is powered up from which is typically 7.2 Volts? Thanks...

Broken / Stripped Servo Joints

I am having problems with the plastic joints stripping out where the servo gear contacts the joint. I have not used this bot but 4 times and he is setup properly. where can I get replacement joints....neck.....leg off of foot. Does anyone have 3d printer files that I can use to print replacements?

Red Pepper Harvesting Robot

Hello friends , I will make an red pepper harvesting robot for my graduation project. It is my homework to graduate . The robot should be able to pick red vegetables from a garden and leave the green or yellow ones. It should perform this task autonomously and without damaging the plant. The Robot will go in a garden , When it detects rep pepper ,...

Logitech Joystick

I am looking into getting a logitech joystick, but I have a question. Does the Logitech joystick connect directly to the V4 EZB or does it require a computer? I just want to make sure it can be stand alone before I purchase the joystick...

Two 7.4 Volt 360 Servo Step Up To 48 Volt 1000 Watt Motors

Looking for recommendations on commercial fabrication of h-bridge for above. Burned up one electrical engineer (not literally) who tried to hook up ezb4 with 48v motor. Looking for someone who is honorable and wants a good day's work for a good days pay. Telemetry 100% complete, body 90% complete, mechanics 90% complete. Perferr performance...

Ez-B And Arduino Shield

After upgrading and swapping to the newer EZ-B board, it would be a shame not to use it with another robot. any consideration to building an Arduino Shield to accommodate the EZ-B? It would be overkill to add an EZ-B to an Arduino, but the potential would open up a wider market and audience. Perhaps the addition of an Arduino Library as well?...

Not Able To Connect To Wifi

After installing a new router in my home I'm finding that I can't get jd to find the internet connection. I had one message that said something along the line of , no dns server found. The robot turns on like normal and shows up on my network list , the robot makes the system noise like its connecting but then stops and an error message comes up....

Voltage Regulation Question

Looking for help! I have a Drok regulator and an 11.2v 5200mah LiPo battery to power my EZB. My EZB keeps telling me my battery is low when I have the battery passing through the Drok at 7v. The problem is that the amps are not pulling through the Drok enough to juice the EZB. The EZB is only receiving .18ah. When I plug my smaller 7.4v LiPo at...