Robot Building Questions

Is It Possible To Convert Bloc

is it possible to convert Blockly to EZ-script?  I have a good routine I want to use that I created in Blockly, but it needs a few tweeks that I need to add in EZ-Script.

New Here And Am Asking Some Qu

New here and am asking some questions. My project is an independent drive via 24 volt Jazzy motors controlled with a Sabertooth 2x32. My wish is to have autonomous operation and have RC over ride. I have an operational RC and operational Arduino autonomous but have not been able to assemble both. Dimension Engineering (Sabertooth) have guided me...

So I Am About To Buy Another L

So I am about to buy another lipo battery for the EZ VB4, the one I was using for my EZ BV4 was a 7.4V, 1300mAh and I was wondering if it is safe to use a 11.1V, 1300mAh. I have read a few threads in this community but I just felt safer in asking if someone has used the 11.1V and has not had any issues burning anything.

Hi, Pretty New To This And Sea

Hi, pretty new to this and searched but couldn't find a answer. I have about 10 servos that run on 5v and I want my ez-b v4 to run them, is the pwm from the v4 ok as long as you power from a 5v source? Thanks!

Hello Everyone,We Have 4 EZ-

Hello everyone, We have 4 EZ-Robot Humanoid JD. The 4 ez-robots are 2 years old. We tried connecting via phone and it worked but the capabilities of the phone software was limited. the PCs we used and had the software recently downloaded wouldn't recognize the robot at all. But one of the teammates who had the software downloaded from the first of...

Hello Community,I Would Li

Hello Community, I would like to deploy something similar to this project NeoPixel Ring with Arduino as control board but I need to use LED strips. 60 LED qty. Will this work for LED strips? Or is there a simpler way to control many LEDs with the EX-B Help is greatly appreciated. Thanks, Mark

We've All Seen It.  The Super

We've all seen it.  The Super Armatron has it, the Omnibot 2000 has it, and if you take away the head of Gypsy from MST3K, it's all you have left!  I am of course talking about those fun bits of rubber tubing that add a clean, industrial flourish to any robot.  I'm in the process of taking an old Robie Sr. and giving it the same treatment that DJ...

I Am Getting A No Internet

I am getting a "no internet" message on ARC Mobile, despite following the procedure on The Robot Program 025. I am connected to the EZB-v4/2 in my Adventure Bot but when I try to get the Remote Control it doesn't happen. I do get internet on my phone through my WiFi network (I don't have a data plan on that phone). My PC has an Ethernet...

Want To Connect A EZ-B V4 WIFI

Want to connect a EZ-B v4 WIFI Robot Controller to Meccanoid Servos using a arduino UNO. Need harware configuration. Arduino code. Sample code to drive the servos Thank you for help.