3dfixer
USA
Asked
— Edited
I have purchased 2 ezb’s and was wondering two things. Where Can I mount them. And how do I connect both at once so the ARCs can move in synchronization.
@3dfixer Use these Servo cable extender
I repurposed Gael's breakout boards by patching in my own power cables (lower right), used ribbon cable, etc to run the signal wires back to EZB (lower left), and used Amazon extension cables (top) to get to the servos from there: https://www.amazon.com/gp/product/B00MIQRN2C/ref=oh_aui_detailpage_o01_s01?ie=UTF8&psc=1
3d Printer Finally got ordered Tues. Just waiting for it to get here. So we can start putting it together and start printing. My question is. for the screws. For putting the parts together. the ones that aren't 3d printed. I already it s going to be a lot, but what kind of screws and what size or sizes . Unless I'm missing something. I didn't see anything in the tutorials that show that part for the screws. Thanks in advanced Paul
That is all called out on the inmoov website
https://inmoov.fr/default-hardware-map/
Hello everyone I'm getting ready to do my first print. I was just wondering if anyone has a certain heating preference for the heating temp for the best print if there is one. I'm using PLA 1.75 filament.
HotEnd 225C Bed 70C All Layers
I'm using Repetier-Host where do I go to select all layers
Just set those temps and if your printer wants to alter them for the first layer, no problem.