Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
DJ's Multiple Robots With One Joystick
Control six robots with one joystick using Synthiam ARC and EZ-B controllers, synchronized head servos and per-direction...
Ezang's New Hand Progress, 3D Printing, Glyphs , Ultrasonic,...
Synthiam ARC controls multi-controller EZ-Robot with 2 Iotiny, 2 EZB4, HDD/996R servos, RGB eyes, camera and motor...
Louis's The Real Wall-E By Louis T
Build a lively Wall-E with Synthiam ARC: custom carbon-fiber parts, geared servos for wheels, neck and arms, animated...
i am printing zoe 's body and hands nowxDalmost done.
Great going Nomad
EzAng
hey EaZang
here's another tip.build a kinda cast arround your printer. to keep the head inside.specially when using ABS . mine needs some glas doors or somethin.
i use the monoprize mini v2 for small parts.I will make a not of this, thanks
What does that do?
EzAng
@EzAng I think Nomad is telling you about adding an enclosure around your printer, if you are printing ABS or Nylon and a few others these filaments cannot cool too fast as they will start to warp and could release from the print bed. no drafts are allowed. and you should allow the enclosure to heat a bit before printing also.
for excample it keeps the wind outside if you have a window open some where. you wanna keep all the heat that your machiene makes inside for makin good prints.
Thanks guys, I need all the tips I can get, lol
EzAng
nallycat, are you familiar with ROS?
EzAng