Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Other robots from Synthiam community
Hoolagen1's Update To My Wall-E
SparkFun MP3 Trigger installation photos and new body tilt plus forward/back and left/right motion controls
Tevans's Help With My R2
Drive full-size R2 scooter motors with ez-b using a suitably rated H-bridge or motor controller matched to motor voltage...
Spooky67's Synthiam : Mars First Contact
Centaurus 2 Mars Rover converts EZ-Robot JD with 3D-printed parts into a drone-launching rover with cameras, rock...
@EzAng I have done some research into ROS and this Robot operating system is a programming language, that can take quite a while to learn and become efficient. As I am a robotist not a programmer I do not have the time to start learning ROS. but who knows it my be usefull to learn.
Looks like Nomads printing is goin well,
EzAng
zoe says look into my eyes
and i will hypnotize you,haha lol
What kind of servos, electronics are you going to use?
EZang
the ones mickey recoment.see link in post #149
i also found this looks same servo's very cheap.
lewansoul servo's
What board are you connecting the servo too?
Mickey uses raspberry board, and python I believe
Iotiny or EzB4 are better, what will you use/
LattePanda running Arc is good
Wonder where Mr. ptp is in all this?
EzAng
for me iff possible ,the ezbv4 but i dont have a clue.:(
use the ezbv4 so you can get it to talk and all the rest
EzAng