Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
DJ's Elastic Band Shooter
Elastic band shooter for hexapod in Synthiam ARC: servo uses a hexapod leg to raise/lower the body for vertical aiming....
David's C3po Ez Robot
Build a C-3PO robot with an EZ-Robot brain and servos, adding hearing, vision, speech, motion and interactive...
Jstarne1's Iotiny Recon 6.0 Rovers , Educational Robots
Convert used robots into IOTINY+camera donor units for durable, kid-safe hands-on robotics demos and classroom...
i am printing zoe 's body and hands nowxDalmost done.
Great going Nomad
EzAng
hey EaZang
here's another tip.build a kinda cast arround your printer. to keep the head inside.specially when using ABS . mine needs some glas doors or somethin.
i use the monoprize mini v2 for small parts.I will make a not of this, thanks
What does that do?
EzAng
@EzAng I think Nomad is telling you about adding an enclosure around your printer, if you are printing ABS or Nylon and a few others these filaments cannot cool too fast as they will start to warp and could release from the print bed. no drafts are allowed. and you should allow the enclosure to heat a bit before printing also.
for excample it keeps the wind outside if you have a window open some where. you wanna keep all the heat that your machiene makes inside for makin good prints.
Thanks guys, I need all the tips I can get, lol
EzAng
nallycat, are you familiar with ROS?
EzAng