Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Ezang's New Video - Using Floor Map And Touch Path Maps And...
Floor Map, Touch Path and Navigator enable simple path following; IoTiny hotspot guides your car-Intel RealSense...
Bhouston's Inmoov's New Gripper
3D-printed syringe-powered universal gripper adapted for InMoov arm; picks up small objects; EZ-Robot OS enables easy...
David's Humanoid Robot
Robosapien V2 upper-body robot with homemade 7-servo arms and Micro Explorers story about tiny robots that combine,...
I am ready Nomad for you to test exosphere now
EzAng
Nomad, what 3d printer are you using?
EzAng
its an creality ender-3 build plate 22 cmx22cmx25 high. self build pakket.low cost 170 euro
Hey guys, unfortunately at the moment ZOE is only using LOBOT LX-16A servos they cost less than 20$/20 on Amazon... Those LX16-A servos are very easy to use with ARC, I chose them because cable management is very easy with Serial Bus Servos!
But you could also wait, because next week, @DJSures will remodel the parts, so you can also use EZ-Robot HDD servos!
Mickey, want to try Exosphere with my robot?
EzAng
hey mikey
i just printed the head.i can adjust averything els.
Nomad, I going to get a 3d printer, thanks EzAng
dont forget to order a glas bed too.and a uhu stick