Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Okidey's Hank V1.0
Control an EZB hexapod (18 servos) with Synthiam ARC scripts; troubleshoot external servo power, brownouts, and...
Kashyyyk's VINCENT From The Black Hole
Vincent robot using Iotiny and Raspberry Pi to run an EKG video on a chest LCD; monitor is bad and awaiting...
Jim's Project Armadeus
ARMadeus Mk7 articulated robot, 48" tall and 112 lb, modular 80/20 chassis with 12V gear motors, servos, linear...
I am ready Nomad for you to test exosphere now
EzAng
Nomad, what 3d printer are you using?
EzAng
its an creality ender-3 build plate 22 cmx22cmx25 high. self build pakket.low cost 170 euro
Hey guys, unfortunately at the moment ZOE is only using LOBOT LX-16A servos they cost less than 20$/20 on Amazon... Those LX16-A servos are very easy to use with ARC, I chose them because cable management is very easy with Serial Bus Servos!
But you could also wait, because next week, @DJSures will remodel the parts, so you can also use EZ-Robot HDD servos!
Mickey, want to try Exosphere with my robot?
EzAng
hey mikey
i just printed the head.i can adjust averything els.
Nomad, I going to get a 3d printer, thanks EzAng
dont forget to order a glas bed too.and a uhu stick