Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Bhouston's A New Dof For Inmoov's Neck/Head
New InMoov neck mechanism adds an extra degree of freedom, improving head articulation; prototype needs fine-tuning.
Justinratliff's Data Or Termidata
Centurion security robot inspired by Cylons, Terminator and Person of Interest, built with Synthiam ARC for...
Cambot1's My Name Is Cameron, This Is My First Robot 6
Homemade robot built by a 10-year-old and grandpa, programmed with custom scripts, learning robotics and sharing...
I am ready Nomad for you to test exosphere now
EzAng
Nomad, what 3d printer are you using?
EzAng
its an creality ender-3 build plate 22 cmx22cmx25 high. self build pakket.low cost 170 euro
Hey guys, unfortunately at the moment ZOE is only using LOBOT LX-16A servos they cost less than 20$/20 on Amazon... Those LX16-A servos are very easy to use with ARC, I chose them because cable management is very easy with Serial Bus Servos!
But you could also wait, because next week, @DJSures will remodel the parts, so you can also use EZ-Robot HDD servos!
Mickey, want to try Exosphere with my robot?
EzAng
hey mikey
i just printed the head.i can adjust averything els.
Nomad, I going to get a 3d printer, thanks EzAng
dont forget to order a glas bed too.and a uhu stick