Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Lumpy's Lumpy's Omnibot(S) - Spy Vs Spy
Omnibot restoration in Spy vs Spy black/white theme with front switches retained, Mr T and Pee-wee audio, wet-sanded...
Toymaker's Dewey (Drone:1)
Iconic 1972 Silent Running drones on display: three scale models of Dewey showcased in my studio.
Mattbrailsford's Omnimc
Convert an Omnibot 2000 into OmniMC media center with Raspberry Pi (RaspBMC), RC control, EZ-Robot kit, screen, battery...
I am ready Nomad for you to test exosphere now
EzAng
Nomad, what 3d printer are you using?
EzAng
its an creality ender-3 build plate 22 cmx22cmx25 high. self build pakket.low cost 170 euro
Hey guys, unfortunately at the moment ZOE is only using LOBOT LX-16A servos they cost less than 20$/20 on Amazon... Those LX16-A servos are very easy to use with ARC, I chose them because cable management is very easy with Serial Bus Servos!
But you could also wait, because next week, @DJSures will remodel the parts, so you can also use EZ-Robot HDD servos!
Mickey, want to try Exosphere with my robot?
EzAng
hey mikey
i just printed the head.i can adjust averything els.
Nomad, I going to get a 3d printer, thanks EzAng
dont forget to order a glas bed too.and a uhu stick