Hello everyone,
I would like to share the new custom firmware available for EZB 4.
Currently i'm beta testing the firmware fixing and polishing the code.
I'm still open for ideas, please comment.
- Initial screen:
- Access point configuration:
- Client/Station mode configuration:
- HOST/EZB configuration:
Ports Configuration:
Tools
Working in progress
I will describe in another post the new features.
By ptp
— Last update
Other robots from Synthiam community
Thetechguru's Long Lasting Roli
Step one of getting ready to experiment with NMS was to make Roli run more than 15 minutes on a charge. A little...
Ezang's My New Crane Robot Video Below
Here is a pictures and new video of my new crane robot, many nuts and screws, servo city parts, two servo blocks for...
Ezang's Simple Bot Car Robot
No frills or thrills - no sensors or lights - I am Simple Bot, I hope you enjoy the simple life sometimes, its good for...
Absolutely fantabulous work @ptp. I wish I had a programmer to load this firmware!
You pretty much hit the nail on the head for my initial ideas about what I felt could be improved in the web interface. Authentication being a big one!
Good job and keep it up!
Programmer is $14 clone off E-Bay... Well worth the investment to do this upgrade.
There is no ebay where I live, and international shipping to here is hit or miss unless you use DHL or similar.
(which is normally 3 times the price of the item) eyeroll
@PTP, Awesome work on this new firmware. I am working on indoor navigation project, is it possible you could add a way to view wifi access points and there signal strength? Also have this info available in ARC My hope is to use 3 APs signal strengths to triangulate my position.
RichardZ
Hello, when will this Firmware for Ezb-v4 be available?
This firmware is for the old discontinued EZ-B v4.x/1. The new EZ-B v4.x/2 has it's own firmware updater - which you most likely have the latest firmware if you've purchased it within the last few months.
Just stumbled across this...slowly getting used to the new forum!!
Great work @ptp