Robot Building Questions

Reducing Sensitivity Setting And Max Speeds

So close to finishing things, I'm stuck trying to make Chopper easy to control. Background I'm using the joystick 1 controls movement, a sabertooth movement panel controlled by an Arduino Uno, Simplified Serial Mode 9600 Baud. 24vdc supplies the Sabertooth to drive 2x 150w motors. The issue I'm having is it's very all or nothing, which would not be...

Issue Saving Project

When I add RPlidar skill I cannot save project. OK if I delete it> Any ideas?

Servo Buttons And Combo Box

I am finding the Servo Buttons and Combo Box are not consistent between the Mobile App and a PC. They actually work on the Mobile App perfectly whereas on a PC, the Combo Box activates a selection before it is clicked, whilst the Servo Buttons require the user to tap +- repeatedly. With the Mobile App, you just slide your finger left to right. Is...

My Camera Is Not Recognized As A Camera Device.

I bought the JD humanoid a few years ago and put it aside for at least 3years. I used ARC before. However, I try using ARC for connecting the humanoid recently but the camera is not recognized. Is there something I missed out? Thank you for your kind assistance

Servo Wont Move Until Second Servo Moves First

Hi all, I have several EZB's in my robot with servos attached to the EZB on connection 2 in ARC. I've got a weird issue I can't figure out with a servo attached to that EZB's D0 port. My problem servo is attached to port D0 with 5 other servos attached to other digital ports, D2 through D6 with D2 not being used. They all work fine except the one...

Raspberry Pi GPIO With Windows 10

Hello everyone;  I'm curious regarding the use of on-board GPIO pins with regards to embedded PC's, such as the Raspberry Pi 3B I am using in my project that have ARC running on them. I am running ARC Teams on this Raspberry Pi to control other EZB's in the robot, and in order to shut the robot off properly, the Pi will need to send a shutdown...

Inmoov Multiple Servo. My Power Supply Will Not Power My Servos

I am going to try to configure this robot using the EZ-B V4. I'm currently trying to power 6 servos for the right hand. The servos are MG996R, they require 6V. I purchase a power supply ( DROK 48V Power Supply, AC 110V/220V to DC 0-48V 10A 480W Buck Converter, Adjustable Variable LED Adapter Regulated 5V 12V 24V 30V 36V 48V Volt Voltage Transformer...