Robot Building Questions

Battery Not Charging

Hello, I keep getting the battery is low message and when I try to charge it, it takes about 20 seconds to charge and I get a green light on the charger saying its ready. As I Turn it back on it starts with the "my battery is low again. I should also mention that the ez robot is right out of the box brand new. Double checked the Battery Care...

How To Create More Glyphs

Is the a glyph encoder? Question - how to create more glyphs? thanks

Best Method For Driving Meccano Wheels & Motors

Need more information on how to connect the Meccano (g15ks model) original wheels & motors to a EZ-B v4? Consider hardware, cost, ease of installation and compatibility with ARC . Thank you for your help, Cesar P.S. I have update the servos with HDD EZB servos, & reconfigured the head & neck servos. I will be adding a EZB...

12C Communication B\W Arduino And Ez-B V4 Wifi Controller

ez-b v4 has  3 i2c connectors so can I connect scl and sda pin of Arduino to i2c connectors of ez-b v4 controller to establish communication b/w Arduino and ez- b v4   which will help in my inmoov project??

Wheel Not Working Properly

Hi there, I have an AdventureBot where the wheel only turns in one direction. I have tried the following: - swapped out motor - switched pin input Any ideas on next steps? Any advice would be great - supposed to be taking it to a show in two days...

Hbridge PWM Only Working On Board 0.

I am not sure whats wrong.  But I've noticed that PWM controls are not working correctly, they sometimes loose connection with the port.  Also I cant seem to get the Hbridge with PWM to work on any board except 0.   Has anyone else had the same issue?

Ez-B With Computer Vision

I apologize if this is a redundant question: but with EZ-pi software used for EZ-b, raspberry pi, does the camera system support identifying and counting objects like computer vision in opencv ?I hope that is possible https://opencv.org/

Servo's On Second EZB

I am running two EZB's on my project.  The second one has two servos connected.  When I run the script command getservo(1.12) or getservo(1.13) it returns zero until I actually issue a move servo command and then it will show the position of the servo.  Has anyone else noticed this issue?