Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
Ezang's Here Is A Picture Of The Hand I Am Practicing With
Photo of the hand I am practicing with
Clode's The Canadian Mars Explorer :-)
Canaxplorer Canadian Mars rover controlled by EZ-B with camera, ping sensor, light sensor, buzzer, spot light and future...
Ericez's Smart Cute Trash Can
Smart trash can prototype detects floor garbage and transforms into a robot, deploying wheels and side 'hands' to...
@PTP
you sure have a point about the crazy stuff
haha.
ez robot controller would be fabulous if we can use that.
lookin forwart to your topic.
thank you
the stl original from the zoe head frame is 1.5 mm higher and 1.5 mm weider. as you can see the frame is 1.5 mm too high and to weid.
i have seen this before with other parts.i gess the cura or TC is not so accurate.
This is very strange...can tell me which slicer software you are using, so I can confirm I am getting the same result?
i am using cura 4.5.0 there is another strange fenomen with cura.when starting up cura,all works fine, except the copie&paste funtions stopped working.you have to reboot to start working again.
Check in Windows so I can see we are having the same numbers...
Which printer are you using?