Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Discover more robots
SBANAS09's Kitty Hawk
Engage 7th graders in STEM with Kitty Hawk aviation program: wing design, watercolor flight art, and EZ-Robot coding to...
Jer361's Romni The Omnibot/Roomba Hack
Omnibot mated to Roomba: a cleaning robot using EZ-Robot kit with camera, servos, sonar and voice for autonomous or...
Steve's Eddie. The I-Cybie & Synthiam Mongrel Robot Dog
Convert an I-Cybie dog to EZ-Robot/EZ-B v4 with servos, camera and sensors, documented build and Synthiam ARC...
@PTP
you sure have a point about the crazy stuff
haha.
ez robot controller would be fabulous if we can use that.
lookin forwart to your topic.
thank you
the stl original from the zoe head frame is 1.5 mm higher and 1.5 mm weider. as you can see the frame is 1.5 mm too high and to weid.
i have seen this before with other parts.i gess the cura or TC is not so accurate.
This is very strange...can tell me which slicer software you are using, so I can confirm I am getting the same result?
i am using cura 4.5.0 there is another strange fenomen with cura.when starting up cura,all works fine, except the copie&paste funtions stopped working.you have to reboot to start working again.
Check in Windows so I can see we are having the same numbers...
Which printer are you using?