Since my robot is running on a Raspberry Pi, which is now supported by ARC, I decided to evolve my current project K[8] into a new one called ZOE... First steps will creating a new servo setup which supports Dynamixel Servos, and a new Conceptual design!!
By Mickey666Maus
— Last update
Other robots from Synthiam community
Urbanh's Target Bot
So heres the Target Bot. D7 is the main servo. D8 is the switch, which uses the GND and Signal cables (no resistors...
Ezang's New Mr. Roman - Happy New Year 2020
New Year 2020 I am using a Arduino - and Ez-Builder
Rb550f's Brookstone Ezb Teleprescence Robot
I put together a teleprescence robot using a Broostone rover 2.0.It stands 39 inches high and has a 7inch android...
great got one ordered.tomorow i have the adafruit says the chippi,g.:)
the mailman has dropped a pakkage.:D do i need to solder the pins?
hi mickey
are these sizes correct? i have 1.5 mm too long with original stl.
Hey Nomad, supercool that you got the Oleds... So the thing is, maybe we need to ask @ptp how we should wire the Oleds? He is inventing a new software....
So do you want to
For the new way the @ptp will be inventing we need this micro controller... https://www.adafruit.com/product/3800
I will also modify the frame that it will hold this board!
The size looks correct, maybe you can just print it and see if the Oleds will fit? If you are running into any issues, let me know...
there where no wires in the box only pins.its very smal
for soldering.
i bouth one extra just incase.great if you can show how to do.
ok i by the board.
the original was 1.5mm higher and weidt didn fit.ok i print new one. do i solder wires on the adafruit or pins?
@Nomad6r, @Mickey66Maus: What an Adventure..... both courageous and crazy
, getting out of the EZ(Easy) comfort zone....
I don't want to spam Zoe's build thread with specific details.
I'll create another thread to explain the OLED wiring, controller and the application. I'm adapting an old project/idea to make it easy to use through ARC. I've plans to integrate with EZ-Robot controller. The idea is not to be dependent on the Raspberry to control the Oleds.