All Community Content

Dinsmore 1525Nd Hall Efect Compass Sensor

I wanted to share my new find with others. at a local hamfest I purchased two Dinsmore 1525ND nd for no damping on outputs electronic hall effect sensors for $5. these sensors have both sine and cosine outputs. I have attached a data sheet for reference. So far the results are pretty good, now to interface it to EZ v4 instead of my development...

Help With Array

Good Afternoon. I want to create an array where I store two string values. For this example I will call it $x and $y. I want to store the variables in the array. I want to store as many as I need. I understand the definearray command. What I do not understand is how to input in the array and keep adding the string variables. Let me post my example....

Ez-Robot Rebooting Every Time I Use A Servo

Hello Everyone, I require assistance once again and I apologize for bothering you, but I have yet another problem. I go to keyboard control and set the w key to Servo(D13,25). I press w and the servo moves but then my EZ-Bv4 restarts and reconnects every time I do this. Thanks in advance, Crazy

Plastic Piece On Left Foot Servo Is Wallowed Out Is Just Spinning On Servo Gear

Finally after dealing with my HP computer that would not pick up the EZB-v4 , I bought a new Dell computer that JD would work on! He is amazing but in doing some already programmed procedures from you, JD fell off the table & wallowed out the plastic that attaches to his left foot so I am down until I can get a replacement part! DJ, your...

Cannot Connect To Ez-Robot

Hello everyone, I have recently bought the Ez-Robot developer kit. I got batteries and assembled everything together. It booted up and I heard the chime. I went to my wifi connections and found it. However it will not let me connect to it. The odd thing is it connected on my other computer that runs windows 7 but it will not connect on my primary...

Battery Question

The green light will not turn on our JD unit. Any advice? The red light comes on but the green light does not when plugged in. It was working just fine until today. Thanks in advance.