EwgBPwKcw0cz!~~60_1-634877148220156250.jpg)
EwgBPwKcw0cz!~~60_1-634870572001250000.jpg)
Ok this is the third of a trio of robots made to run around outside with first person view ez robot wireless cameras. Each has airsoft automatic guns and some kind of dart launcher.
By jstarne1
— Last update
Other robots from Synthiam community
Cliffordkoperski's Hydrualic Arm And Hand
Hydraulic system operated with EZB4 controller
Morbeious's Alpha (Dev Servo Bot)
Dev Servo Bot using Ez-bit parts and recycled materials: CD-case caster, cable clip, hot-glued frame and sonar for...
Bhouston's A New Hand For Inmoov?
InMoov hand hack: Exiii Handii modified for independent finger control, wrist with EZ-Robot lever servo, EZBv4 control...
Hope it holds for you.
If it doesn't , no worries. I will buy lock tite for rc racing motors. Before doing that however i may consider upgrading to higher voltage / torque motors.
Team starnes gets the first shirt made . This is a tester. If I like it I will have a better one made and add ezrobot logo .
Dude! Lookin' gooood.
Thanks bret! Im still trying to figure out whats happenning in this gearbox. I took it out agian today to play with and noticed that one side still sounds like the pinion breaks loose or something. Now it just makes a spinning noise and nothing moves. Really weird. So I may need to get lock tight for plastic pinions to hold this little guy one. In the mean time im looking to buy spare rad base for the gearboxes just in case this one gives me problems.
Tiny update : Its my Birthday! Woop woop! Besides that awesome news dispite a drop of ca on the pinion it still broke loose and spun freely . :/ I may need to rough up the shaft with 60 grit and put lock tite on there. Up until the pinion breaks loose everything runs smooth. I may switch to a l298n motor driver because I don't like the constant armed beep /tone from these controllers..
Happy Birthday and I hope you can get it running smooth again!
Happy Birthday Josh!