cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Other robots from Synthiam community
Rb550f's Meet Ewa
EWA robot: Walle Ucommand rebuild with 3D-printed head, EZB V3 controller, HD servos, LED mic-reactive mouth, 5000mAh...
Djandco's Djandco's Wall.E
EZ-B Wall.e arm mod using small Arduino servos to retain clutch and deliver about 80 arm travel; neck servo planned.
Steve's R2-D2 Hasbro Toy Hack
Upgrade a 2002 Hasbro R2D2 with EZB v4/v2, sensors and EZRobot controls to revive voice features and introduce beginners...
Yes, But be careful. That stuff gets all over Everything. It comes in a tube and a spray can.
I will get the kind in the tube but first I will dynamat the inside of the case while it is still clean and grease free.
yes i have both works very well ,same use in servo's on pla stic gears spray can is better,because of the very small tube and can get in to small places that the lube tube cant
this one better then the lube (blaster powerfull white lithium grease)
white lithium grease in a can also ace hardware and homedepot might carry it,i think i bought it there
lube type does have very much in it
Ok tonight I will lubricate the gears. I need to test the base moving with weight on it.
I have a few things left to do so I can finally paint him!
1sand top of torso 2sand up vacuum and mid torso 3 mold in smooth the speaker grills 4.clean Tv mount 5.drill mounting holes for shoulder holes 6.cut vacuum door off 7.fill elbow opening.GA 8.install video card cradle 9.epoxy /fiberglass in steel axles to stiffin the frame 10.,create mount for DVD drive to be strapped to.
Not much left kids! Then he gets painted!
i see a lot of work,but do see its getting close to paint
I am over half way done with the rear ext. I molded the top and bottom. Tomorrow will be the sides.
Those shoulders look wicked! And the rest - hardly resembles the donor bot at all. Fantastic work Josh.