Omnibot 2000 , Rad 2.0 Vacuum Bot

Skip to comments Jump to end

This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.

By jstarne1 Jan 2012 — Last update Mar 2013

Jump to end

Other robots from Synthiam community

Upgrade to ARC Pro

ARC Pro is more than a tool; it's a creative playground for robot enthusiasts, where you can turn your wildest ideas into reality.

Compare Pro Features View Subscription Plans

jstarne1

USA

#1601 Aug 2012

I'll try to find the link, it's single sensors though, not a array. I bought there for good measure. I was thinking.of making my own array.

robotmaker

USA

#1602 Aug 2012

there is one that has 8 mikes in array,for a omnisound pick up,problem with putting mikes in array is crosstalk between each one ,unless its dont right,it takes special shielding besides foam,copper shielding the mike array is called the superbeam array by andrea its a great microphone and has a bundle with USB-SA usb adapter card that is so good,i bought 5 of them and really work great,pickup persons with sound in the round,and working on automatic voice scanner circuit it use a few chips and a servo

andrea superbeam microphone

jstarne1

USA

#1603 Aug 2012

Been drilling for ultrasonic sensor mounts , there on Jarvis Jr and there on Jarvis base. I installed the speaker grills and IM thinking of molding the seam all the way around the edge.

This last one is the small robots base, Jarvis Jr

Robotmaker , the Mic sensors only.measure.how.loud.noise is.in that direction. So I will only use one Mic for audio input.