cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Other robots from Synthiam community
Rickymahk2013's MARK X
Launch of first robotic product built with ARC Software; WorthyBot seeks Kickstarter support after years of...
Jstarne1's Diy Awesome Project Case Made From Netgear...
Build a custom, low-cost project case from used routers for $12 using a Dremel and superglue to house a light, fan and...
DJ's Snow Shovel Robot
Remote-control 80 lb mobility-scooter robot fitted with a shovel using Synthiam ARC, EZ-B controller and Sabertooth...
Assembled and painted sure , finished.... I don't know about that. Reading the selection process sounds like they are not interested in individual work only famous / mass.produced robots. Even so it would be awesome even to be nominated!
:) Just saying that you're building a cool bot.
you meen you finally got it painted
No paint till I get him sanded up, he's getting.there lol hopefully this mouse helps me get Jarvis shaped up very.quick.
WHEN you are looking to remove gears or pinions of motors a very good tool so you dont damage the gear or motor is a gear puller ,ebay has it cheap ,i bought both sets while back since i do alot of servo making
gws gear puller tool its very close to gear puller i have made for cars ,but a lot smaller
Thanks I appreciate that.
Julie is sanding on Jarvis , she asked to work on him lol.
She really did a good job
Ok so the two zoomed in pictures are showing that the edges of the body filler and original plastic meet smoothly, and these are 2 separate pieces!
It's coming along, the back must have some filler added and fill.some various gauges but the.first sanding.came out really well.