I've designed a new neck mechanism for InMoov to add a degree of freedom. It still needs some fine tuning but you'll get the idea.
By bhouston
— Last update
Discover more robots
Ericez's Rori The Coffee Robot For Movie
DIY low-cost robots and tutorials: donated EZ-Board enabled 3D-printed Rori coffee robot for an Indonesian web series,...
DJ's Robotis XM430 Dynamixel Arm With Open CM9.04
Robotis arm pick-and-place setup with Open CM9.04 controller and firmware upload tips for reliable grasping
Kashyyyk's R2-Q5 Droid Build With Ez-B4
R2Q5 3Dprinted droid using EZB4: camera in dome, RGB LED magic panel, servos with buck converters, scripts for panels,...
Will do. Thanks again.
Just for the record, I don't know why Anthony posted a picture of his latest render on this thread, it really doesn't have much to do with the thread. It is not a remix of a design by me but rather a remix of the original design by Gael Langevin the creator of the InMoov robot. Anthony's design will not fit on my modification unless it is modified. I have asked Anthony a couple of times to remove it from this thread - but he doesn't want to. I just think that comments made on a "Project Showcase" thread should be about the project being showcased!
Ok one more kick at this! This part -Throat piston V2 ( from InMoov website/downloads) I referenced was designed by Gael Langevin. @Anthony, if you are going to leave your design on this thread, please change the attribution for the design you remixed to Gael Langevin. Thanks Buddy
@Anthony? What are you doing dude? This is Bob's thread... he doesn't post his stuff in your thread(s). I think you should have some respect....
Hey Bob. I started printing this but had to abort it. I realized that I didn't have enough filament to complete the print. I have more on order which should be here tomorrow. I plan on starting the neck and head again tomorrow. I will let you know the results.
@ Bob, So far so good, I have the upper and lower neck joint done and they fit perfectly,
I'll make a short video when everything will be fit together.
Regarding Antony's modified Throat piston V2, its modification looks nice and is a good idea, except he should reference Gael Langevin as the original author.
Hi,
for everbody who don't want to make work to change the STL files from inch to millimenter.... here i did it for you.
All STL for the Neck Upgrade from Bob Houston in millimeter.
https://www.thingiverse.com/thing:861146
Boris www.thingiverse.com/thing:861146