Here is Mr. Metal again for those who missed him.
Might need to turn up volume
Please leave a comment,
Thanks
EzAng
By EzAng
— Last update
Discover more robots
Rb550f's Found An Old Freind
Experimental Omnibot hybrid (Omnibot 2000 + Emiglio/Scooter) with functioning remote control and motorized arm; includes...
Jeremie's Treat-O-Matic 2020
Convert a claw-style candy machine into a contactless Halloween dispenser with Atomic Pi, Arduino EZB, camera, PIR,...
Thetechguru's Long Lasting Roli
Extend Roli's runtime for NMS experiments with a 7200mAh internal battery installed after a precise Dremel mod, boosting...
Nomad, finishing up on my "Thing" hand - tips are not on the fingers yet
Sunday I should have for parts
EzAng
ezang
that is very need printing .
I am learning my machine, tweaking is the name of the game :-)
I recently printed the rotation wrist, found out I can use this for any project I need the servo to rotate.
EzAng
ezang
did you test the gears inside the wrist ? mine doesn fit properly . its some 1 MM off .
I had to sand and file the large gear to fit in the whole
After that, I used the large gear, screwed it on the servo, then placed it in the wrist. I had to drill two wholes on the wrist so I could screw the servo on to it.
I will take pictures
ezang
i test tomorow a new set .where you can screw on the real horn on.
Here are my pictures:
the gear in the gear on the servo wil not last long . thats why i change the file a little .