Here is Mr. Metal again for those who missed him.
Might need to turn up volume
Please leave a comment,
Thanks
EzAng
By EzAng
— Last update
Discover more robots
Jphillipsnj's 6 Servo Arm Using Vb.Net, Visual Studio 2010...
Control EZ-B servos with VB: set positions, speeds, timed sequences and releases for wrist, shoulder, elbow and jaw.
Luis's R2d2 Project Ready To Document
Open-source R2D2 build: Arduino sensor controller with ultrasonic foot sensors, Razor/Saber Tooth motors, PS4/EZB...
Cardboardhacker's Ez-Ollie
ez-Ollie: recreate Sphero Ollie with a simple low center-of-gravity build for stable rolling, easy forward drive and...
Nomad, finishing up on my "Thing" hand - tips are not on the fingers yet
Sunday I should have for parts
EzAng
ezang
that is very need printing .
I am learning my machine, tweaking is the name of the game :-)
I recently printed the rotation wrist, found out I can use this for any project I need the servo to rotate.
EzAng
ezang
did you test the gears inside the wrist ? mine doesn fit properly . its some 1 MM off .
I had to sand and file the large gear to fit in the whole
After that, I used the large gear, screwed it on the servo, then placed it in the wrist. I had to drill two wholes on the wrist so I could screw the servo on to it.
I will take pictures
ezang
i test tomorow a new set .where you can screw on the real horn on.
Here are my pictures:
the gear in the gear on the servo wil not last long . thats why i change the file a little .