Here is Mr. Metal again for those who missed him.
Might need to turn up volume
Please leave a comment,
Thanks
EzAng
By EzAng
— Last update
Discover more robots
Jdebay's Mini-Zip V3 Upgrade.
Repair and upgrade a Dagu RS024 12-servo hexapod: v3 controller install, mini-servo replacement, and learning...
Buratino's Basilio
Basilio 45cm 3D-printed walking robot with 26 DOF, external potentiometers for pose capture, seeking EZB/EZ Robot...
David's C3po Ez Robot
Build a C-3PO robot with an EZ-Robot brain and servos, adding hearing, vision, speech, motion and interactive...
Nomad, finishing up on my "Thing" hand - tips are not on the fingers yet
Sunday I should have for parts
EzAng
ezang
that is very need printing .
I am learning my machine, tweaking is the name of the game :-)
I recently printed the rotation wrist, found out I can use this for any project I need the servo to rotate.
EzAng
ezang
did you test the gears inside the wrist ? mine doesn fit properly . its some 1 MM off .
I had to sand and file the large gear to fit in the whole
After that, I used the large gear, screwed it on the servo, then placed it in the wrist. I had to drill two wholes on the wrist so I could screw the servo on to it.
I will take pictures
ezang
i test tomorow a new set .where you can screw on the real horn on.
Here are my pictures:
the gear in the gear on the servo wil not last long . thats why i change the file a little .