Here is Mr. Metal again for those who missed him.
Might need to turn up volume
Please leave a comment,
Thanks
EzAng
By EzAng
— Last update
Other robots from Synthiam community
Mickey666maus's Oled Animated Eyes For ARC Pro And ARC Free
Control ItsyBitsy M4 OLED eyes from Synthiam ARC via serial: flash firmware, send animation numbers over COM ports and...
Animator28's AVA Advanced Visual Android
Human-size 3D-printable legs with parametric slew joints; 550 DC or NEMA17 steppers via adapter; L298N/EZ-B/Arduino...
Justinratliff's Walle Built With Iotiny
Updating software and wiring a small non-motorized WallE: servo port mapping, using stock toy switches on one ADC line...
Nomad, finishing up on my "Thing" hand - tips are not on the fingers yet
Sunday I should have for parts
EzAng
ezang
that is very need printing .
I am learning my machine, tweaking is the name of the game :-)
I recently printed the rotation wrist, found out I can use this for any project I need the servo to rotate.
EzAng
ezang
did you test the gears inside the wrist ? mine doesn fit properly . its some 1 MM off .
I had to sand and file the large gear to fit in the whole
After that, I used the large gear, screwed it on the servo, then placed it in the wrist. I had to drill two wholes on the wrist so I could screw the servo on to it.
I will take pictures
ezang
i test tomorow a new set .where you can screw on the real horn on.
Here are my pictures:
the gear in the gear on the servo wil not last long . thats why i change the file a little .