cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Discover more robots
Lumpy's Lumpy's Hasbro R2-D2
Modify Hasbro R2 with EZ-B control, L298 motor driver and 12V LiPo for compact, upgradeable internals, planned dome...
Troy's Meet Pinhead!
Concept model scale mismatch: stacked components and an overly long neck.
David's Humanoid Robot
Robosapien V2 upper-body robot with homemade 7-servo arms and Micro Explorers story about tiny robots that combine,...
Now that's a goody box!
Ok I cut the brass pinions off the shaft which was very easy and tapped on the Delrin pinion from Troy. Next I must cut out the original plastic mounts and adhere two motors together.Ok I cleaned the sides of the motor cases off and cut off the plastic lip so they can be epoxies together. They are.perfect, they are off about a mm but they still line up with the first input spar gear.
I cut away one mount which was simply too short. Here you can see how two motors would mesh up to the input spargear.
Ok I checked out the meshing on the gears, they look to fit together well. I did a HD test video, sorry about the noise the camera is like 12 inches and sometimes closer to the gearbox which has no grease in it or a cover.
Test video!
https://www.youtube.com/watch?v=Q5w6XiU_3Ho&feature=plcp