All Community Content

Does The Camera Have To Be Attached To The Servos That Move It

hello Had an idea, since my wall e has a bunch of servos and light in his eyes, i wont be able to install my ezb cam in the head.... i was wondering.... if set up the camera above my monitor (stationary, separate from my wall-e) and i assign the wall-e neck servos (neck left and right and neck up and down) to the camera will wall-e head move (as if...

How To Cut Plastic Without Melting It

here is a idea kinda close to what they use at factory ,like where i work and desgign using platics,sensor and more for in-house tester what i made i took a old wet saw and replace the blade with a stainless steel fine tooth blade and made shore plenty of water is inside the machine,can also make your own too go very slow cut stop and go again,cuts...

Where Is The Ez-B Manual?

Hey guys, In the early days of EZ-Robot, I think a manual in a PDF form, was easily access on this site. Where is it? The one the site now is not what Im looking for. I need some answers for the questions: If anyone could help, that be great.. Max current/amp: 5amp? hence the 5amp fuse Max current/amp on a single I/O: DC current per I/O pin:...

How Can I Change My Email Address In My Settings

Sorry to bother everyone with this but I can not find any information on how to change your email address. If you can help it would be great. BC

Parallax Ping Sensor

HI EVERY ONE, HAS ANY ONE TRIED TO USE THE PING SENSOR FROM PARALLAX, IT ONLY USES THREE CONNECTIONS, THE GRN,PWR,AND SIGNAL. THE ONLY SENSOR LISTED FOR THE EZ-B IS FOR THE HC SR04.

New Motor Controller

So the new motor controller offered by DJ: This looks just like my stepper motor controller (in fact I think it is). Can this control standard DC motors and stepper motors? Does anyone have a wiring diagram for hooking it up to the EZ-B? and I apologize for all my comments on the other posts, I was just trying to move that Robots-Suck off the page....

Script Help Please. How To Move Multiple/Relative Servos At The Same Time?

Hello, i am working on scripts to add to my personality generator, to make wall-e awesome. I am trying to do a , "flashing eyes" script i have to move 2 servos(one in each eye) to move up and down at the same time. and the "tilt" feature by Glickclick (uses 2 servos to make wall e "tilt forward" by voice control...

Voice Recognition Help...

Hello, Making great progress on my wall e.... I purchased a microphone for the pc and cant seem to get voice recognition to work. I have followed the instructions, set the volumes and levels.....uv meters reads my voice at mid way like Sures intructions show.... i think i have the microphone set up correctly but form some reason the speech box isnt...

New Arduino Sensors....Little Help

Hello, I just picked up some sensors for my wall-e 1 parallax ping sensor 2 parallax PIR sensors and 1 china maid smoke sensor (cool right?) All sensors have 3 pins coming from them, I also bought a bunch of female to female servo cables...so i can connect all sensors to ezb with no soldering. the parallax sensors, i feel will be pretty straight...

About Connecting To 2 Ezb With Bluetooth

working on makes a wireless robot controller using bluetooth using 2 EZB one on the robot and one on my controller,on my controller do i need to add small computer with EZ software installed or just the board