Omnibot 2000 , Rad 2.0 Vacuum Bot

Skip to comments Jump to end

This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.

By jstarne1 Jan 2012 — Last update Mar 2013

Jump to end

Other robots from Synthiam community

Upgrade to ARC Pro

Get access to the latest features and updates before they're released. You'll have everything that's needed to unleash your robot's potential!

Compare Pro Features View Subscription Plans

bret.tallent

USA

#305 Apr 2012

Man Josh, that looks like a lot of work. Too bad you don't have a drill press (bench top models are pretty cheap). You could chuck up the wheels for rotation and use any number of tools (triangular file maybe) to make those grooves. Just a thought.

jstarne1

USA

#306 Apr 2012

@brett. It only took 20 min to finish that wheel , I would be done.before I got.back from harbor frieght tools with a new press lol. Oh I didn't know till I recieved my solarbotics pan/tilt kit but I need a micro servo , my standard are way too big.

I'm determined to have a video card in this machine. I must raise the motherboard mounting position 1/2" vertically , after a few measurements I found I have wiggle room..

I do have about 1/4 in wiggle on remounting the axles lower as a last resort as well. I want to.avoid it but I will cut.the nvidia fan shroud as a last resort as well.

bret.tallent

USA

#307 Apr 2012

Dude, I'll send you a micro servo. Just email me your address again. Need anything else? Sonar sensor?

robotmaker

USA

#308 Apr 2012

dude looks like your omnibot when done will weight a ton dont need a mill machine for harbor freight, just a dremel drill base and a second drill to turn the wheel super simple and easy to use and make and can make a pro cut in seconds