cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Other robots from Synthiam community
Justinratliff's Jd Backpack
JD backpack mockup anchors into JD's middle slot with male clip, two top posts, dual rear mounts, wire access and switch...
Jstarne1's Ryobi 40V Robot Mower With 40V Trimmer Whiskers...
Back to building robots after moving to Chattanooga and starting a fiber optics technician role - resuming robotics...
Steve's Navigation Test Robot With Intel Realsense T265
Navigate an iRobot Create using Intel RealSense T265 and EZB with Synthiam ARC for reliable visual tracking navigation...
Anyone have a win 7 key and.maybe a copy of it?
wont do any good without the cd
That's what I meant by a copy of it , or a copy on a usb.thumb drive
no what i meed you need the windows 7 cd to go with the key, the key matches the cd
Ok update , I started cutting the track groove in the center of a wheel , first one was difficult but I bet.I can.do the other three faster. First I had to make a template so that when I mark each wheel.they are the same. Then cut dead center all.the way around. Lastly I must bevel.the edge with my dremel them hit it with sandpaper to get any buggers off.
It seems to turn smooth but I want to make the other three a little tighter to reduce and play.
I see your room mate cleaned the robot destroying debris off the stove! To bad you dont live closer , you could come over and whip those wheels out on something I have here. I still feel really bad about the robot body and all the work you had put into it. JW
Yea I didn't have the heart to work on it all weekend , I do have a replacement body already but when you work for a couple days to get it all just right. I picked up a sock backup and robbed the brain over the weekend.
what you need is a milling machine,if you have a xy table and a drill press you can make like a milling machine easy,it would make very even grooves,othr way is easy is to have the wheel mounted to a drill and have the dremel stationary and have the height adjustable,they do have a drill press for dremel tool,i use mine alot,most bought every attachment i can get for my dremel tool ,xpr4000 model lastest one but still you are getting there,good to see you have close to finish
my roomba project has just a few more days and it will bbe done,almost 4 feet tall with many sensor added
i see you like using the blue painters tape too