Hello EZ Robot! Meet Dusty, he is a omnibot torso and I currently have the choice of robbie at head or a omnibot done where you can see inside. He will handle a few basic functions and us made more simple than his big brother Jarvis.
- He can vacuum (which is loud) with power brush and impeller
- He can "sweep" nearly silent by running the power brush at a reduced voltage and a small DC blower providing low level auction. 3.dusty will have two germicidal bulbs ,.one facing downward to the floor and another behind intake fans that not only cool electronics but it pulls air through a Honeywell two stage carbon filter. 4.dusty has 4 build in filters foam pre filter , and 3 carbon filters.
- He will have a camera on pan tilt bracket. He will be controlled by Bluetooth or wifi.
- Long runtime , 2 x 12v 7ah batteries.
Any other suggestions guys?
]
By jstarne1
— Last update
Other robots from Synthiam community
Moviemaker's Bob And Marty
Photos of Bob, Marty, Leaf & MEL and Fred - quick snapshots uploaded to share and enjoy.
DJ's Ez-Robot Takes The Secret Challenge Competition
EZ-Robot sponsors kids building an Off-Roadbot for Western Canadian Robot Games-assembling platform, motors, controller,...
Wolfie's Well Its A . Start
Convert an RC snowcat into a robot chassis: test servos, wire an H-bridge to an EZ-B controller, and power up a working...
I was thinking as far as color either red or blue
. I'm not sure if I will spare the expense of a automotive grade paint job like Jarvis but I agree , white is plain and basically standard for robots. We want to exceed the standard
. Its already late tonight so I'll continue modding tommorow.
OK a couple hours with a careful hand and a dremel has yielded results. The area where the leds in the head were has been removed. I did keep the frosted plexiglass cover. I started cutting the hole for the lenses by tracing them with a marker. My secret to success was to hold the cutting tool at the same angle I wanted the lenses to peek through. .
When I use my flash my phone color corrects the picture and you cannot see the glow but I assure you its very cool looking. Only outside in the sun or a very bright room would it appear washed out. What does everyone think?Just before I call it a night ( because I finished the cam mod at 1130 pm) I did some fitting in the chest area. I want to mount ezb either vertically where the plastic window is above the tape deck. If that's not possible then I want to do horizontal. I took pics of both positions...
looking awesome Josh!
Very nice! I like how the camera antenna fits perfectly at the back.
Thanks guys! The good news is I've only lost the ability to blink from the mod but I believe I can mount a micro servo on the bottom and use a pushrod to move them instead. Even if I ditch blinking its not a big deal , robots don't need to blink anyways lol.