Robot Building Questions

Li-Po Battery Questions

I have always followed the instructions in this tutorial about the care and use of Li-Po batteries... but I still have some questions synthiam.com/Community/Tutorials/26?courseId=4 I haved read other several articles that caution about "trickle charging" Li-Po batteries which is why I always disconnect the charger when its done. My...

Diameter Eyes Jd Front

i am gonna let a jd chromed .some issues i need to overcome is. the eyes .when chroming a part its all or nothing.so that will cover, jd's eyes.what i was thinking was to dril them out,let the part chromed, and then put some plexi over the holes.so i need to know ,hows the, diameter of jd's eyes on the front part.here's a video how it looks, with...

Raspberry Pi Offline Speech Recognition

I was scouring the internet this afternoon, and came across this project. It's a stand alone sound pattern recognition program for raspberry pi, which can be used as speech recognition for verbal commands. I have to do more research into it, and start experimenting, but I wanted to mention it on the forum in case someone had already, or if someone...

Volt Board

it i solder a wire straight on the spkr from the ezbv4,howmany volt wil, that be?i have a black and red wire .

New Arm Mod Jd

would this be a good idea to ad a servo more to the arm jd. original the arm is 15 cm long,with this mod it is 18 long. so a dummy servo would be good,between the legs and body. some kinda case for the two servo 's to put in. picture of dummy servo's video

New Products

Hello DJ, Any updates and approximate dates for the release of new products? Ron

Onemorequestion About Power Supply

OK, the way I do it is to have 12V and 6 volt and 5 volt power sources. I start with my batteries which are two 12V lead Acid 9ah batteries wired in Parallel. I use the 12Vfor the motors, the 6V for the servos and the 5V for the signal sensors, etc. Then I hook all the grounds together and pull a positive wire off of each. I run the plus wire to...