OK pretty simple idea here. I have noticed actual project cases are usually very ugly and very expensive. Then even if you find a good deal it may be very difficult to get a similar or matching case later. Ooooh the problems today's nerds face right? Here I will show how I used 12 dollars worth of used and probably broken routers , a dremel and a few drops of super glue to make a cool case.
. I will use it to house a light , fan and ezb but you can customize your application!
By jstarne1
— Last update
Discover more robots
Ezang's My New Crane Robot Video Below
New crane robot built with Servo City parts, dual servo blocks for strength and a servo winch pulley; photos and video...
Linux's New Desktop For Modification To Installation In To...
Refurbish Emachine PC into quad-core 8GB system with 4TB storage, projector, WiFi and power brick for Omnibot 2000,...
Luis's I2c Ezb Arduino1 Sensor
Use an Arduino as an I2C sensor controller for EZB3/4 to read PING ultrasonics via Ez-Builder with simple Arduino and...
I like it when a plan comes together,,, re-purpose, re-cycle, EZ.
Super EZ! First step is grab two or three ( or more) matching routers. You can do this with most net gear routers , some linksys , bell in ext. First off routers are great looking and because they come out so often finding a used one or broken one on craigslist or eBay is usually easy.
First we need to take the router apart. I found I had to use a t4 security bit. I carefully marked the first router and after a few seconds of trimming I was able to line up the case and place some masking tape on them to hold them in place.
I ran a bead around the seam both inside and out of super glue and the pieces were held secure by tape...
Next I wanted to add an extra layer to make a triple stack... I carefully trimmed the edges again except this time I left the posts that the bottom panel can still screw to.I'm making this case as a permanent replacement for the experimental led light and a ezb controller of course
. Here are comparison pics
Side by side you can see one is twice as tall. That's more room for electronics
My idea is to increase lighting to 2 or three rows of three LEDs for a total 60 to 90 watts wow!
Three stacking the routers is perfect to fit two 60mm fans ( and double stacking will fit 3 40mm fans)Blue LEDs are on the way from China. I have considered using the two whites I already have but I may replace them. In the future I'm mounting LEDs with screws for easy replacement.
I will more than likely mount the ezb upside down for easy wire access from the bottom.
Great tips Josh! THanks as always.
Who says robots have to be Ugly , good Job!
Thanks guys! I love to reuse cool items in different ways