Topic about 3d printing. How to start with 3d printing.
By Nomad 6R
— Last update
Discover more robots
Ericez's I Create Baymax Doll Robot For Robot Theater Using...
Interactive Baymax robot for Big Hero theater: handmade costume with internal robot, Ez-B v4 for speech and...
Luis's Jd Is Getting A Car
Prototype JD shoe box car with photo and link to usage details on Synthiam community.
Djandco's Djandco's Wall.E
EZ-B Wall.e arm mod using small Arduino servos to retain clutch and deliver about 80 arm travel; neck servo planned.
thingvers owl
hi perry
about 10 houres.
top bat case bottem case i always wanted to make a batterie case.wel and i did.
there are two parts ,one slide in the other.there is a pin and hole in the back. there is room for a tiny screw ontop or a tire wrap in front.as in pic. the case is a little bit bigger then the lipo batt.just incase it chould swell up. printing time is about 2.5 hour per part.i hope you all find it usefull.merried owls
hey perry look at this koppel.so awesome.