Topic about 3d printing. How to start with 3d printing.
By Nomad 6R
— Last update
Discover more robots
Kazobond's Dude (Another Inmoov)
Power Inmoov with a portable LiPo JumpStart and dual Castle BEC-Pro regulators (7.4V & 6.0V) to match EZB-V4 servos,...
Jstarne1's Iotiny Recon 6.0 Rovers , Educational Robots
Convert used robots into IOTINY+camera donor units for durable, kid-safe hands-on robotics demos and classroom...
Cardboardhacker's Rc Car Ez-Fied
Modify RC truck to run dual DC motors with Sabertooth 2x12 and EZ-B V3, using gearboxes and standard servo steering...
thingvers owl
hi perry
about 10 houres.
top bat case bottem case i always wanted to make a batterie case.wel and i did.
there are two parts ,one slide in the other.there is a pin and hole in the back. there is room for a tiny screw ontop or a tire wrap in front.as in pic. the case is a little bit bigger then the lipo batt.just incase it chould swell up. printing time is about 2.5 hour per part.i hope you all find it usefull.merried owls
hey perry look at this koppel.so awesome.