Topic about 3d printing. How to start with 3d printing.
By Nomad 6R
— Last update
Discover more robots
Jstarne1's Meet Rc-Xd Airsoft Droid Dual Wield Gunner...
RC-xd Airsoft Droid: modified Omnibot on a rad 2.0 base with dual automatic airsoft guns and EZ Cam for Mech Wars, built...
Markthebotbldr's Drone Tracking Fun
DJI P4 active tracking follows a hacked Friendly Robotics Lawnbot using Sabertooth motor controller, switchable EZ-BV3...
Joseph4760's Wall-E To Wall-E-Nator
Wall-E-Nator custom build: Wall-E U-Command fused with Terminator parts, mid-build, adding LEDs, camera and painting...
thingvers owl
hi perry
about 10 houres.
top bat case bottem case i always wanted to make a batterie case.wel and i did.
there are two parts ,one slide in the other.there is a pin and hole in the back. there is room for a tiny screw ontop or a tire wrap in front.as in pic. the case is a little bit bigger then the lipo batt.just incase it chould swell up. printing time is about 2.5 hour per part.i hope you all find it usefull.merried owls
hey perry look at this koppel.so awesome.