Topic about 3d printing. How to start with 3d printing.
By Nomad 6R
— Last update
Discover more robots
DJ's Tamiya Bulldozer Robot
Convert Tamiya Bulldozer to use modified servos for precise speed control and greater strength, driven and controlled...
DJ's Hey Jd, Need A Lift?
JD was a little lazy today, a lighthearted glimpse of a laid-back moment.
Bumsteadsean's Synthiam Spray Steam Mop
Convert a Shark Steam Spray Mop into an EZ-Robot Steam Spray Mop-DIY robotics upgrade inspired by Team DJ
thingvers owl
hi perry
about 10 houres.
top bat case bottem case i always wanted to make a batterie case.wel and i did.
there are two parts ,one slide in the other.there is a pin and hole in the back. there is room for a tiny screw ontop or a tire wrap in front.as in pic. the case is a little bit bigger then the lipo batt.just incase it chould swell up. printing time is about 2.5 hour per part.i hope you all find it usefull.merried owls
hey perry look at this koppel.so awesome.