cE9s4PsOgeBQIORwjd5!~~60_1-634818020230156250.jpg)
BO)Lupuc4g~~60_35-634706297915000000.jpg)
LupbT6!~~60_35-634706298769375000.jpg)
C5j!~~60_35-634655044863125000.jpg)
C5j!~~60_35-634659603510781250.jpg)
C5j!~~60_35-634651704046230469.jpg)
This project has evolved some , the basic rundown is I'm modding two Omnibots , one a regular the other a larger 2000 model. I will have two ezb kits , rad base idea was thrown out because of so much noise but could go back on the table if the omnibot drivetrain is too weak to pull it.
By jstarne1
— Last update
Discover more robots
Perry's Scratch
Gimbaled eyepod 'Scratch' with EZR camera, NeoPixel iris, servo X/Y gimbal and 3D-printed belt/pulley cross-mount for...
Kenny's Aiwabot
Convert a Roomba Dirt Dog into a servo-armed robot with EZ-B, camera, multiple servos, regulators, grippers and OLED...
Donesvarc's Wall-E From Czech Republic
Build a custom WallE robot with parts list, servo mods, wiring tips, cameras, sensors, LEDs, audio and power solutions...
Yes 800 oz should be plenty for grabbing drinks. I tried getting another pair 5995ttg servos but they were completely out and won't have any more from servo city.com. I needed one for each.elbow and one for each.shoulder. Anyone have 2 they would sell?
Ok badnews, the shaft is 1/2" too long to mount so I either must eliminate the side to.side shoulder.joint or I must cut.1/2 inch off each shaft so I can mount the side to side shoulder bracket. I am famous for cutting things so IM betting I will go that route. Everyone please lookout for a hitec 5995tg as I need two of them. I would gladly pay for.them. Sorry about all the random periods my phone is.sticking them everywhere again.
i thought you said you will have servocity modify them for you
josh couple of things about the vga to tv adapter,one i got it works on 2 boards i have both board have tv MODE in adapter settings,i dont think the 3 rca type you got may work go to control panel then display/settings/advance then grapics card if doesnt support it then you need the converter,you will need a vga cable and rca male to male video cable,best way to go is get a tiny rca male to male adapter or use a cable and take up room i tried both last night BOTH DO WORK
Those are impressive servo set-ups. They look uber-cool.
are you going to mount them glue them
I will mount them with Allen screws, no glue
Hi josh
You should call your robot omniROID with muscles like those .
GOOD JOB .
Steve_C.
thats about what mine is but 6 million dollar omnibot ,after the movie 6 millon dollar man,not in cost but in strength JOSH IT LOOKS GOOD,on mine using a 6-1 gear box same gear box as yours ?,but using hs-5995tg to give about double the pounds 1600 oz compare to 800 oz,why dont you use HS-5995TG AT 417 oz instead of the 240 oz