All Community Content

Ebay Wall-E Prices

So, is DJ's hack of Wall-E the reason that the U Command Wall-Es have skyrocketed in price on e-bay recently? Are we, DJ wantabes, just bidding against each other? But seriously, I think the prices have gone so high lately that scratch building Wall-Es body is within reason. My only concern is how to build his tracks. Does anyone have any good...

Glickclick!!! Where Are You! Quatar, I Know, I Know....

yo! long time no talk....lets see for progress...i was able to do the body titlt...i will post a video tonight...(california time) thanks for your help man. i hope all is well and i hope to see some updates from ya soon. Carlos

Question About Alternate Powered Servos

I have several servos tied into an alternate power source with the signal wire coming from the EZ-B. Question: When those servos are tied into the alternate power do they draw any current when the signal wire is not energized (ie. the EZ-B is turned off)? I want to know if I need to put an on/off switch in line with the power to those servos?...

Dj About The Ez Board

what crystal does it use and caps

Connection Problems

Hi Everyone, Maybe someone can help me out. I am unable to connect to the EZ board. There are no com ports listed under the "Connection To EZ-B" window. I tried to locate the board under my bluetooth settings as well however it was not discovered. I finally have a little free time so I am looking forward to getting this up and running....

Ez-Board - Some Questions

At last I have received my Complete Robot Kit! Once again big thanks to you! I have some questions about my EZ-Board: 1. What appointment of 6-pin connector on EZ-Board? It is designated as: (-MCLR * 3.3 * 5V * Gnd * Gnd * Vin) 2. On my EZ-Board V3, Rev1 there is no R1 and C1. The diode D1 is soldered differently. It is updating? 3. If the resistor...