Robot Building Questions

Sound Movements...How To....

Greetings everyone, I would like to add two microphones for left and right, allow my robot to respond to the direction of sound. Can you provide a link to what type of microphone to use with the EZ-B? and also provide an example script. thanks

Add Sound To The Robot

Hey , i found this https://www.ladyada.net/make/waveshield/index.html looks beter than the mp3trigger . . . or not ??? grts helmut

Text To Speech Software.

Has anyone found a relatively simple to use TTS that would produce an awesome "Robot" voice?? I have Ultra HAL but it is loaded with glitches. I'd like to be able to change the default voice ( I have Microsoft Anna) to a really nice robot sound. Any help appreciated. Lloyd

Update On My Ez-Robot

I am just starting with my EZ-Robot. It will be a Wallee. I have most of my function software writen and on the bench at the moment. track servos - arm servos - look left / right servo - look up / down servo - distance sensor /servo Couple of questions are beginning to pick at me. Once I install all this hardware into my Wallee, will I be dependant...

Sonar Sensor Range And Width / Height

Hi , I'm trying to figure out how far / close the sonar sensor sees. Also how wide /tall is the beam on the sonar at 1 to 3 ft out. I'm thinking of making a moving radar out of the front acessory door of omnibot 2000 base. That's about 7 to 8 inches from the floor.

Female To Female Servo Cable?

Hello, making tons of progress on the wall-e. To the point i am now getting close to start adding sensors. I purchaed motion detection ir sensors and a 3 pin ping sensor. from radio shack Since i dont have any, and i mean any, soldering skills....can i just use a female to female cable to connect a sensor to the ezb? i found a female cable with no...

Question: Two Way Connection?

So I'm looking at the Tutorial videos for my father who is interested in this kit... I see a typical "Linvor" type Bluetooth interface on the board, so I've got a pretty good idea of what to expect from the connection.. (or so I thought.) The instructions indicate to connect the software to the lowest COM port, (Usually the Incoming port...

Hello From Belgium

Hi there , My name is helmut , 33 years old. Before i flied with the arducopter(qaudcopter). But after a few crashes i decided to stop it and sell everything. I found this site , and this is a good alternative for me. No more crashes , also electronics and with my ongoing study in ICT i can also try some program. So , i just buy the startkit and...

BV4113 Motor Controller

This is an EZ-Robot Certified Economy Motor Controller. It is capable of 1.5 Amps (5 Watts) between 5 and 12 volts DC. This convenient motor controller connects to the EZ-B by a single cable. The cable to the EZ-B provides +5, GND and Signal for the Motor Controller Communication The other connections are for your motors and motor power. * The IC...