Robot Building Questions

Any Eta For Neo Pixel Blaster

I remember reading on a thread that fall could be the potential time for new product releases. Any idea when that may happen? I'm in particular looking for the Neo Pixel Blasters. How will the control be implemented on these devices, I.e how will you be able to choose color and will you be able to create sequences etc?

Cannot Connect To Camera

What EZ-Robot or product are you using? Developer Kit Is the battery on the robot fully charged? Yes Does the robot make a startup sound when powered on? Yes What color is the light on the EZ-B v4 and is it flashing or steady? Flashing blue Are you connecting the device to the WiFi network of the EZ-B v4 by following the video instructions on this...

Can I Use A Lo Tiny With Qunqi 2Packs L298n Motor Drive Controller Board Module

I have looked at the instructions on Hbridge in tutorials. I was wanting to use a Li Tiny but the instructions on the plugin uses a EZ-B 4-2. The EZ-B 4-2 has more ports and the instructions are calling out for higher numbered ports than Lo Tiny has. What do I need to do to use Lo Tiny. Here is the link to the Hbridge I want to use....

Speech Phrase

When comparing phrases recognized by the speech recognition with the string I typed in, the result was always false. The reason is the following: If a speech phrase is recognized it is stored in the variable with lower case letters even if the phrase was written in the wait for speech command with a mix of lower case and capital letters.

Enabling And Disabling Trained Objects Using A Script

Hi, I'm wondering if there is a way to write a script to select and deselect the objects that I have trained. I know how to have a script enable and disable Object Tacking, but I can't figure out how to have a script to automatically select and deselect the trained objects that have been saved, so that I can have the camera only track the saved...

Why Doesn't This Script Work Any More?

I have just switched over to the new 3 port Ultrasonic Sensors and this script will no longer work. It's the one I used for the 4 port Ultrasonic Sensor. The script always Prints 2 no matter how close I get an object to the sensor. $Center = GetPing(D11,D11) $close = 40 :start if($Center < $close) print(1) else Print(2) endif Sleep(2000)...

Does Tires On Roli Exist ?

hi did anyone used some tires on roli? insteadt off rups.