Robot Building Community

New Sensor P.I.X.Y Camera

i found this really fast camera. new camera

Wiimote Question

Hi, I ordered a WiiMote Motion Plus and found out after the fact that it is incompatible with ARC. This is stated in the tutorial. Is there a work-around? From what I see on Amazon all of the WiiMotes are Motion Plus except for a couple of used ones. Tom

Ezb4 Controller

Which power supply portable or ac adapter that I can use for the ezb4 controller? MC....

Camera Image Freezes

Camera Disabled Camera Initialized: EZB://192.168.1.1 @ 160x120 EZ-B v4 Camera Error: System.IO.IOException: Unable to read data from the transport connection: A connection attempt failed because the connected party did not properly respond after a period of time, or established connection failed because connected host has failed to respond....

Accessing Engenius Eap350 With More Then One Ezb

On the advice of fellow members of this forum I bought an EnGenius EAP350 a while back. The thinking was to give my EZB an access point with a stronger signal to access then my network's wireless router. It worked like a charm. Here's my question; I now have 3 EZB's in my robot and have noticed that only one is using the EnGenius EAP350 as an...

Digital Pins Not Working

All the digital pins on one of my 3 EZB V4's stopped working. I rebooted and reset the unit and still can't get the 3 volts at any of the digital pins when I try to turn them on through ARC. I probably burned something up on the EZB but was wondering what type of mishap would cause them all to stop responding? I'm a little leary to just swap out...

Lekrunda Right Leg

right leg middle servo wrong way.head not in the middle

Ez-B V4 Disconnects Whenever I Try To Move The Servos

i am working on making a custom six robot that I am modeling after the Ez Robot six robot, I am running 12 servos of of 5 rechargeable 1.2 volt AA's, I have already set the battery monitor to 5.2. The servos I am using are 3 EZROBOT HD servos, 3 Tower pro MG995 hi-speed servos, and 6 GWServo so3 STD servos. what happens is I connect to the ez-b...

Commotion Motor Driver / Mecanum Wheels

I've been having a look at the ComMotion motor driver as an option to drive two motors much like a Sabertooth. With the onboard encoder counting, it should be possible to create something via serial or i2c that acts like a Kangaroo. My thought is that I could later get two more motors and some omni/mecanum wheels in the future for another platform...